臥式砂漿攪拌機適用于建筑科研建筑公司及干粉砂漿廠試驗室蝇罐，可攪拌干粉砂漿和普通混凝土，也可用到其它行業試驗室對不同物料進行攪拌的設備矢勉。

Horizontal mortar mixer is suitable for the construction scientific research and construction company and the laboratory of dry powder mortar factory. It can mix dry powder mortar and ordinary concrete. It can also be used in other industries to test equipment for mixing different materials.

臥式砂漿攪拌機技術參數：

■進料容量：18升合弥；

■出料容量：15升；

■大出料容量：20升固蛾；

■攪拌均勻時間：≤45秒结执；

■攪拌軸轉速：45轉/分

■電源電壓：380V-1.5千瓦；

■外形尺寸：1130×400×900mm;

■毛重：110KG

Technical parameters of horizontal mortar mixer:

■ Feeding capacity: 18 liters;

■ Discharging capacity: 15 liters;

■ Large discharge capacity: 20 liters;

■ Stir time: ≤45 seconds;

■ Rotating speed of stirring shaft: 45 rpm

■ Power supply voltage: 380V-1.5 kW;

■ Dimensions: 1130 × 400 × 900mm;

■ Gross weight: 110KG

臥式砂漿攪拌機結構：

由拌筒艾凯、加料和卸料機構献幔、傳動機構坚芜、機架和支承裝置組成。

砂漿攪拌機通過軸與傳動機構連接的動力機構帶動的滾筒斜姥，在滾筒筒體上裝圍繞滾筒筒體設置的齒圈鸿竖，傳動軸上設置與齒圈嚙合的齒輪，來實現攪拌工作铸敏。砂漿攪拌機結構簡單缚忧、合理，采用齒輪杈笔、齒圈嚙合后闪水，可有效克服雨霧天氣時，托輪和攪拌機滾筒之間的打滑現象蒙具；采用的傳動機構可進一步保證消除托輪和攪拌機滾筒之間的打滑現象

Structure of horizontal mortar mixer

It consists of a mixing drum, a feeding and discharging mechanism, a transmission mechanism, a frame and a supporting device.

The mortar mixer is driven by a drum driven by a power mechanism connected to the transmission mechanism. The drum cylinder is provided with a ring gear arranged around the drum cylinder, and the transmission shaft is provided with a gear meshing with the ring gear to achieve the stirring work. The structure of the mortar mixer is simple and reasonable. After the gears and ring gears are engaged, it can effectively overcome the slippage between the supporting roller and the mixer roller in rainy and foggy weather; the transmission mechanism can further ensure that the slipping between the supporting roller and the mixer roller is eliminated phenomenon

臥式砂漿攪拌機操作規程：  

■啟動前**先檢查旋轉部分與料筒是否有刮碰現象嬉哥，如有刮碰，應及時調整勒蜀。 

■ 減速箱應注入機油后方能使用津咒，卸料蝸輪及滑動軸承處也應注入機油。 

■清理料筒內雜料雁碘，將筒體限位裝置鎖緊哩拔，然后啟動機器，如在啟動后發現運轉方向不符合要求時啥拘，應及時切斷電源影焙，將導線的任意兩根相線互換位置，再重新啟動血肯。 

■ 將混凝土拌合物裝入料筒內襟笋，合上筒蓋，根據攪拌時間調整時間繼電器的定時（必須在斷電情況下調整）途居。 

■按動啟動按鈕抵肌，主軸便帶動攪拌鏟運轉，達到設定時間后自動停車桑孩。 

■卸料時先停機拜鹤，然后將料體位限制受柄松開，再旋轉手輪流椒，由蝸輪帶動料筒旋轉到便于出料的位置敏簿，停止轉動，然后啟動機器使主軸運轉方可排出物料宣虾，直至將料排干凈停止主軸運轉惯裕，旋轉手輪使物料筒復位。 

■清洗料筒绣硝，將水到入料筒內使主軸運轉將料筒內殘余物料清洗干凈或用砂子清洗也可

Operation rules of horizontal mortar mixer

■ Before starting ** Check if there is any scratch between the rotating part and the barrel. If there is any scratch, adjust it in time.

■ The reduction gear box should be filled with engine oil before use, and the discharge worm gear and sliding bearing should also be filled with engine oil.

■ Clean up the miscellaneous materials in the barrel, lock the barrel limit device, and then start the machine. If the running direction is found to be inconsistent with the requirements after the startup, the power should be cut off in time, and any two phase wires of the wire should be interchanged. Restart again.

■ Put the concrete mixture into the barrel, close the cover, and adjust the timing of the time relay according to the mixing time (must be adjusted in the case of power failure).

■ Press the start button, the main shaft will drive the mixing shovel to run, and it will stop automatically when it reaches the set time.

■ When unloading, stop the machine first, then release the material position restriction and handle, and then rotate the hａnd wheel. The worm wheel will drive the barrel to the position convenient for discharging, stop the rotation, and then start the machine to make the spindle run to discharge the material until Stop the spindle to run cleanly, and turn the handwheel to reset the barrel.

■ Clean the barrel. Put the water into the barrel and run the spindle to clean the residual material in the barrel or use sａnd to clean it.